This is an example shows how to write texts on SSD1306 OLED display (128×64 pixel) using PIC16F887 microcontroller. In this project the SSD1306 OLED is configured to work in I2C mode, make sure that your SSD1306 OLED display is configured to […]
Interfacing PIC microcontroller with SSD1306 OLED | mikroC Projects Read More >>
This post shows how to use PIC16F887 microcontroller USART module in order to receive and send data from and to PC serial monitor software (hyper terminal, Arduino IDE serial monitor tool, mikroElektronika USART Terminal …) or any device that uses
UART Example with PIC microcontroller | MPLAB Projects Read More >>
This post shows how to decode IR (Infra-Red) remote control that uses the Philips RC5 protocol using Microchip PIC16F887 8-bit microcontroller. Decoding results are printed on 16×2 LCD screen. The compiler used in this project is Microchip MPLAB XC8 (MPLAB
RC5 Remote control decoder with PIC microcontroller | MPLAB Projects Read More >>
This topic shows how to decode IR (Infra-Red) remote controls which use NEC protocol (NEC and extended NEC) using PIC16F887 microcontroller. Results are displayed on 16×2 LCD screen. The compiler used in this project is Microchip MPLAB XC8 (MPLAB X
NEC Remote control decoder with PIC microcontroller | MPLAB Projects Read More >>
The HC-SR04 ultrasonic sensor module can measure distances form 2 cm to 400 cm (4 m) with an accuracy of 3 mm. The HC-SR04 module includes ultrasonic transmitter, ultrasonic receiver and control circuit. This post shows how to make a
Interfacing PIC MCU with HC-SR04 ultrasonic sensor | MPLAB Projects Read More >>
This project shows how to control a DC motor speed and direction of rotation using PIC16F887 microcontroller and L293D motor driver chip. The L293D quadruple half-H drivers chip allows us to drive 2 motors in both directions. With one PWM
DC Motor speed and direction control with PIC MCU | MPLAB Projects Read More >>
The DS18B20 temperature sensor is a 3-pin electronic component (like a simple transistor) from Analog Devices (formerly Maxim Integrated) which uses 1-wire protocol to communicate with master device (microprocessor, microcontroller ….). The DS18B20 sensor provides 9-bit to 12-bit Celsius temperature
Interfacing DS18B20 Sensor with PIC MCU | MPLAB Projects Read More >>
This post shows how to build a real time clock with 2 alarm functions and temperature monitor using PIC16F887 microcontroller and DS3231 RTC IC. Time, date, alarms and temperature are displayed on 20×4 LCD screen. Time, date and alarms are
Real time clock with alarm and temperature monitor | MPLAB Projects Read More >>
The LM35 temperature sensor is a three pin device (VCC, OUT and GND) with an output voltage linearly related to Centigrade temperature. Since the LM35 output varies with dependent to the temperature we need an ADC (Analog-to-Digital Converter) module to
Interfacing LM35 sensor with PIC microcontroller | MPLAB Projects Read More >>
LM335 Sensor is a 3-pin analog device which can measure temperature (converts temperature to analog voltage). This sensor requires an ADC to convert the analog data into digital data. This post shows how to build a simple thermometer using PIC12F1822
Interfacing PIC microcontroller with LM335 sensor | MPLAB Projects Read More >>