This post shows how to build a half wave controlled rectifier using Arduino uno board and one thyristor (SCR). No warranty is provided with this project, do it at your own risk! SCR: Silicon Controlled Rectifier. The SCR (thyristor) is […]
220V Half Wave Controlled Rectifier with Arduino Read More >>
This is another Arduino project for beginners, it shows how to control LED ON and OFF with push button where the LED changes its state whenever the pushbutton is pressed. In this project, Seeed Studio Grove LED socket kit and
Using Arduino and Seeed Studio Grove ultrasonic ranger we can easily build a distance meter. This project shows how to do that where distance value is printed (in centimeters and inches) on Grove LCD (I2C 1602 LCD display) and Arduino
Interfacing Arduino with Grove Ultrasonic Ranger Read More >>
This topic shows how to build a simple temperature & humidity measurement station using Arduino uno board and Seeed Studio Grove DHT11 sensor module. The values of temperature (in °C) and humidity (in %) are printed on Grove LCD (1602
This small topic shows how to interface Arduino with Seeed Studio Grove LCD display that has 16 columns and 2 rows (16×2). This display communicates with the Arduino over I2C bus which means it requires only 2 data pins. Currently,
Interfacing Arduino with Seeed Studio Grove LCD Read More >>
This Arduino project shows how to build a 4-digit digital up/down counter using Seeed Studio Grove 4-digit display. This counter is incremented and decremented using two Grove button modules. The Grove 4-digit display module is shown below (face): And the
Arduino Digital Up/Down Counter with Grove 4-Digit Display Read More >>
This Arduino example is for beginners, it shows how to make an LED blinking using Seeed Studio Grove LED socket kit which is shown below: As shown in the Grove LED board there is a variable resistor of 10k ohm
Arduino LED Blink with Seeed Studio Grove LED Socket Kit Read More >>
This article shows how to easily play wave audio files (files with .WAV extension) using Arduino UNO board. The Arduino loads wave audio files from FAT16 or FAT32 formatted SD card and a simple PC speaker is used to amplify
Drawing bitmap images (.BMP format) on ST7735 TFT display is quite easy because they are uncompressed images unlike JPEG images (.JPG format). This post shows how to draw bitmap images on the ST7735 TFT using Arduino UNO board where the
Draw Bitmap Images on ST7735 TFT with Arduino and SD Card Read More >>
This Arduino tutorial shows how to interface the UNO board with ST7789 TFT display. The ST7789 TFT module contains a display controller with the same name: ST7789. It’s a color display that uses SPI interface protocol and requires 3, 4
Interfacing Arduino with ST7789 TFT Display – Graphics Test Example Read More >>