This post shows how to interface Arduino uno board with Seeed Studio Grove DHT11 sensor and 4-digit display. The Arduino reads temperature & humidity values from the DHT11 sensor and print them on 4-digit 7-segment display which is also provided […]
Arduino with Grove DHT11 Sensor and 4-Digit Display Read More >>
This Arduino project shows how to control DC motor speed using full wave controlled rectifier. The speed of the DC motor is controlled using a potentiometer (connected to the Arduino board) by varying the value of the firing angle ‘alpha’
In the last project I made a half wave controlled rectifier using Arduino UNO board and one thyristor (also called SCR). This topic shows how to build a full wave controlled bridge rectifier using Arduino uno, 2 thyristors and 2
Arduino 220V Full Wave Controlled Bridge Rectifier Read More >>
This post shows how to build a half wave controlled rectifier using Arduino uno board and one thyristor (SCR). No warranty is provided with this project, do it at your own risk! SCR: Silicon Controlled Rectifier. The SCR (thyristor) is
220V Half Wave Controlled Rectifier with Arduino Read More >>
This is another Arduino project for beginners, it shows how to control LED ON and OFF with push button where the LED changes its state whenever the pushbutton is pressed. In this project, Seeed Studio Grove LED socket kit and
Using Arduino and Seeed Studio Grove ultrasonic ranger we can easily build a distance meter. This project shows how to do that where distance value is printed (in centimeters and inches) on Grove LCD (I2C 1602 LCD display) and Arduino
Interfacing Arduino with Grove Ultrasonic Ranger Read More >>
This topic shows how to build a simple temperature & humidity measurement station using Arduino uno board and Seeed Studio Grove DHT11 sensor module. The values of temperature (in °C) and humidity (in %) are printed on Grove LCD (1602
This small topic shows how to interface Arduino with Seeed Studio Grove LCD display that has 16 columns and 2 rows (16×2). This display communicates with the Arduino over I2C bus which means it requires only 2 data pins. Currently,
Interfacing Arduino with Seeed Studio Grove LCD Read More >>
This Arduino project shows how to build a 4-digit digital up/down counter using Seeed Studio Grove 4-digit display. This counter is incremented and decremented using two Grove button modules. The Grove 4-digit display module is shown below (face): And the
Arduino Digital Up/Down Counter with Grove 4-Digit Display Read More >>
This Arduino example is for beginners, it shows how to make an LED blinking using Seeed Studio Grove LED socket kit which is shown below: As shown in the Grove LED board there is a variable resistor of 10k ohm
Arduino LED Blink with Seeed Studio Grove LED Socket Kit Read More >>